How do we proceed to disassemble a lamp and why?
There are two reasons why we would disassemble a lamp:
1. We are going to hang the lamp in a different location.
2. The lamp is defective ( Go to step 2)
1. We are going to hang the lamp in a different location.
When we move a lamp to another room or site, we first reset it to its factory settings.
We do this to ensure a smooth onboarding at the new location.
To reset a lamp, we proceed as follows:
We log in via the app on the mobile device.
We go to the housing unit where the lamp is located.
We press edit and then arrive at the screen with the general information of the room.
Here we go to rooms and select the three dots at the bottom of the room where the lamp hangs.
Here we go to rooms and select the three dots at the bottom of the room where the lamp hangs.
We choose edit device.
Then we choose Factory reset.
The app will now look for the device and you will see the six letter code
After you have received the code you select it and press link at the bottom right
You will receive the message that after approximately 1 minute the lamp will light blue again.
When this is the case and the lamp flashes blue again, we are ready to disassemble the lamp.
2. Dismantling the Nobi lamp
We need the following tools for disassembly:
- A small flat-head screwdriver
- A 2mm Allen key
We proceed as follows:
We first turn off the fuse for the lighting.
Then we will use the flat screwdriver to disconnect the plug in the lamp.
We place the screwdriver as shown in the photo in the provided opening and press it out.
Now we can pull the plug from the socket and the lamp is disconnected.
We then have to disconnect the three steel cables from the lamp.
We do this by holding the lamp and pressing down the opening where the steel cable goes.
You can now lower the lamp and the cable will come loose.
You do this for the three cables.
The lamp is now completely loose and can be stored.
For the last part we need the 2mm Allen key.
The four black screws on the side of the power supply are loosened. The cover will now come off.
Now it is just a matter of loosening the 3 wires by pushing on the tabs so that you can pull out the wires. This applies to both the wires of the lamp and the wires coming from the ceiling.
Finally, you just need to unscrew the mounting plate.
Now you are ready to move the lamp to another location